Thecus N5500 User Manual download pdf (Page 39)

System Network

Use the System Network menu to make network configuration settings as well as

service support settings.

WAN Configuration

From the System Network menu, choose WAN, and the WAN Configuration

screen appears. This screen displays the network parameters of the WAN

connection. You may change any of these items and press Apply to confirm your

settings. See a description of each item in the following table:

WAN Configuration

Item Description

Host name Host name that identifies the N5500 on the network.

Domain name Specifies the domain name of the N5500.

WINS Server To set a server name for NetBIOS computer.

MAC Address MAC address of the network interface.

Jumbo Frame Support Enable or disable Jumbo Frame Support of the WAN interface on your

N5500.

IP Sharing Mode When enabled, PCs connected to the LAN port will be able to access the

WAN.

Link Aggregation Specifies whether WAN and LAN ports will be aggregated and act as one

port.

Load Balance: Ethernet traffic will flow alternative between two Ethernet

ports.

Failover: When one port fails, the other one will take over.

802.3ad: Linkage two Ethernet ports in parallel to increase throughput.

Set IP Address by:

Static / Dynamic

You can choose a static IP or Dynamic IP, and input your network

configuration.

IP IP address of the WAN interface.

Netmask Network mask, which is generally: 255.255.255.0

Gateway Default Gateway IP address.

DNS Server Domain Name Service (DNS) server IP address.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 148 149

No comments

Thecus N5500 User Manual Page 39