Thecus 6TB M3800 HDMI 1080P User Manual download pdf (Page 12)

Chapter 2: Hardware Installation

Overview

Your M3800 is designed for easy installation. To help you get started, the

following chapter will help you quickly get your M3800 up and running. Please

read it carefully to prevent damaging your unit during installation.

Before You Begin

Before you begin, be sure to take the following precautions:

1. Read and understand the Safety Warnings outlined in the beginning of

the manual.

2. If possible, wear an anti-static wrist strap during installation to prevent

static discharge from damaging the sensitive electronic components on the

M3800.

3. Be careful not to use magnetized screwdrivers around the M3800’s

electronic components.

Hard Disk Installation

The M3800 supports three standard 3.5” Serial ATA (SATA) hard disks. To install

a hard disk into the M3800, follow the steps below:

1. Remove the front panel of the M3800.

2. Unscrew the thumbscrews which are securing the hard drive rails.

3. Remove the hard drive rails and install them to your SATA hard disk(s).

4. Slide hard disks into the M3800 until they snap into place.

5. Replace the thumbscrews.

6. Replace the M3800 front cover.

NOTE

If your HDD was part of a RAID 1 or 5 array previously, it automatically rebuilds. If

you replace all the drives with higher capacity drives, you need to go to

Administrator login and format the drives.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 103 104

No comments

Thecus 6TB M3800 HDMI 1080P User Manual Page 12