Thecus N8800SAS User Manual Page 21

  • Download
  • Add to my manuals
  • Print
  • Page
    / 150
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 20
2009/05/22 12:00 Current system time.
Disk Info Current status of disk slot has been installed
RAID Current RAID status.
The N8800SAS will rotate these messages every one-two seconds on the LCD
display.
USB Copy
The USB Copy function enables you to copy files stored on USB devices such as USB
disks and digital cameras to the N8800SAS by press button. To use USB copy, follow
the steps below:
1. Plug your USB device into an available USB port on the Front end.
2. In Display Mode, press the Down Button ().
3. The LCD will displayUSB Copy?
4. Press Enter (
) and the N8800SAS will start copying USB disks connected to
the front USB port.
5. All of data will be copied into system folder named “USB copy”.
Management Mode
During setup and configuration, the LCD will be in Management Mode.
To enter into Management Mode, press Enter (
) and an “Enter Password” prompt
will show on the LCD.
At this time, the administrator has to enter the correct LCD password. System will
check whether the correct LCD password has been entered. The default LCD
password is “ 0000 ”. If correct password is entered, you will enter into the
Management Mode menu.
Management Mode
Item Description
WAN Setting IP address and netmask of your WAN ports.
LAN Setting IP address and netmask of your LAN ports.
Link Agg. Setting Select Load Balance, 802.3ad or Failover.
Change Admin Passwd Change administrator’s password for LCD operation.
Reset to Default Reset system to factory defaults.
Exit Exit Management Mode and return to Display Mode.
NOTE
You can also change your LCD password using the Web Administration
Interface by navigating to System Management >Utility>
Administrator Password. For more on the Web Administration
Interface, see Chapter 4: System Management.
Typical Setup Procedure
From the Web Administration Interface, you can begin to setup your N8800SAS for
use on your network. Setting up the N8800SAS typically follows the five steps
outlined below.
For more on how to use the Web Administration Interface, see
21
Page view 20
1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 149 150

Comments to this Manuals

No comments