Thecus N4200PRO User Manual download pdf (Page 32)

CPU Fan Current CPU fan status

2009/05/22 12:00 Current system time.

Disk Info Current status of disk slot has been installed

RAID Current RAID status.

The Thecus IP storage will rotate these messages every one-two seconds on the

LCD display.

USB Copy

The USB Copy function enables you to copy files stored on USB devices such as USB

disks and digital cameras to the N8800 by press button. To use USB copy, follow the

steps below:

1. Plug your USB device into an available USB port on the Front end.

2. In Display Mode, press the Down Button (▼).

3. The LCD will display “USB Copy?”

4. Press Enter () and the N8800 will start copying USB disks connected to the

front USB port.

5. All of data will be copied into system folder named “USB copy”.

Management Mode

During setup and configuration, the LCD will be in Management Mode.

To enter into Management Mode, press Enter () and an “Enter Password” prompt

will show on the LCD.

At this time, the administrator has to enter the correct LCD password. System will

check whether the correct LCD password has been entered. The default LCD

password is “ 0000 ”. If correct password is entered, you will enter into the

Management Mode menu.

Management Mode

Item Description

WAN/LAN1 Setting IP address and netmask of your WAN/LAN1 ports.

LAN2 Setting IP address and netmask of your LAN2 ports.

Link Agg. Setting Select Load Balance, 802.3ad or Failover.

Change Admin Passwd

Change administrator’s password for LCD operation.

Reset to Default Reset system to factory defaults.

Exit Exit Management Mode and return to Display Mode.

NOTE

You can also change your LCD password using the Web Administration

Interface by navigating to System Management >Utility>

Administrator Password. For more on the Web Administration

Interface, see Chapter 4: System Management.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 152 153

No comments

Thecus N4200PRO User Manual Page 32